Filter replacement: 1200 TLNew water filters from 4200 TL

Monday–Saturday, 08:30–19:00+90 543 346 07 74

When Should Water Filters Be Replaced?

The short answer: pre-filters are replaced roughly every 6 months, the membrane every 12–18 months. But these intervals can be shorter depending on how hard your water is, how much your household uses and the model of your system. Below we explain why each filter needs replacing and how to tell when it is time.

A used filter clogged with sediment next to a new filter

Average intervals by filter

FilterAverage intervalWhy is it replaced?
Sediment6 monthsIt fills with trapped sediment and the flow slows down
Granular carbon6 monthsIts capacity to hold chlorine runs out
Carbon block6 monthsAs it fills, chlorine starts to get through to the membrane
Membrane12–18 monthsIts pores clog and the rejection rate falls
Post-carbonUsually 12 monthsIts taste-improving effect fades

Remember that these intervals are a starting point. The same system wears at different rates in two different homes.

What shortens the interval

The biggest factor is the water itself. Because Antalya's mains water is hard, pre-filters fill up before 6 months in some homes. If there has been a fault or pipe replacement on the mains, sediment entering the water can clog the sediment filter quickly.

Usage matters too. In larger households that use only filtered water for cooking, tea and coffee, the filters treat more water and fill up faster. If you have been away for a long time, it is a good habit to drain the first water sitting in the tank when you return.

Signs that it is time to replace

  • The water flows more slowly than before, or the tank takes longer to fill.
  • The taste or smell of the water has changed.
  • The TDS value has started to rise. Systems with a display show this directly.
  • The sediment filter in the clear housing has turned brown.
  • More than 6 months have passed since the last replacement.

One of these signs on its own may not mean the filters need replacing, but if two appear together it is time for a check.

Sediment filter turned brown with deposits, next to a new filter
A sediment filter removed during a filter replacement in Antalya (left) next to a new one. The brown colour is the sediment it has trapped.

What happens if you leave it too late?

When the pre-filters are full, two things happen. First, the flow drops and the system fills the tank more slowly. The second matters more: once the carbon filters can no longer hold chlorine, chlorine reaches the membrane. The membrane is sensitive to chlorine; its life is shortened and it needs replacing sooner than usual. In other words, putting off the pre-filters by a few months can mean replacing the membrane earlier.

Can I replace the filters myself?

On some systems the filter housings can be unscrewed by hand, so replacing them yourself is technically possible. Still, there are things to watch out for. The filter must be the right size and quality for your system. If the connections do not seat properly, water can leak under the sink. The first water from new carbon filters also has to be run to the drain. Measuring TDS after the replacement is the only way to confirm the job was done properly.

We show the steps with photos taken on real jobs in our article How to replace water filters.

Filter replacement in Antalya

In Antalya we replace filters at your home: it takes about 30 minutes, and afterwards we measure TDS and check for leaks. Prices start from 1200 TL; details are on our filter replacement page. In Kepez and Muratpaşa we can usually come out on the same day.

Have a question?

We offer a free home visit and water test in Antalya. Message us on WhatsApp or give us a call.